Skip to main content

How to install HHo kit


HHO-water gas mixing  with CNG, gives about 25-50% CNG saving.
Injecting in to engine with patrol in a carburetor vehicle also give same fuel saving as we have taken in Hho-water gas with CNG.
To use Hho in an efi vehicle needs some electronic circuits.
How to inject HHO in CNG using vehicle?
Parts required: (wire to connect with Battery and ignition switc, Relay, light, Water reservoir, bubbler, rubber  pipe.
1- Install HHO kit in a vehicle.
2- Take one wire from ignition switcch, connect it with relay coin.
3- Connect water reservoir water delivery pipe to bottom of hho kit and from gas output pipe of hho kit to the top nozzle of water reservoir.
Take one pipe from water reservoir and connect with bottom nozzle of bubler and from bubler take this rubber pipe to air filter and connect it after drilling a hole in air filter.
Electrical connections:
1-     Connect positive terminal with positive of kit with relay’s off point and output point of relay is connected with hho kit positive point via a 20 Amp fuse box.
2-     Connect negative wire of kit with negative of Battery.
3-     Take a wire from ignition switch and connect with relay coil and other point of relay coil connect with battery. it will only start the kit when the engine will be started and produced gas will go directly in to the engine and burnt.
4-     Start the vehicle, reduce CNG quantity by turning adjusting knobs of CNG kits till engine get smooth i.e engine will only be given cng as desired by engine and this reduced Cng will be compensated by hho gas generated by installed hho kit.


Comments

Post a Comment

Popular posts from this blog

how-2-save-fuel cost

Water gas Car Hho/water gas/oxyhydro gas saves fuel We conducted different test for saving CNG and patrol/gasoline fuel with HHO kit or water gas. In our experiments two strokes and 4 stroke normal engines without any alteration were used. 1- Two stroke 600 c.c 2-   Four Stroke 1000 c.c 1300 c.c. patrol engine have been used. HHo kit has been installed to produce fuel and injected it with CNG fuel via air intake filter. Fuel system: In my experiments both the types old carburetor type and modern EFI engine have been used to observe the fuel saving effect. Case -1 : HHO (about 0.0.5 to 0.75 L/min)is   added to air mixture of patrol engine of 600 c.c and 1000 c.c engine). Case-2: 1 L/Min HHO was mixed with CNG and   inducted via air intake(air filter). Case-3 About 1.75 L/min HHo gas inducted in a van having patrol engine of 2700 c.c. In all above mentioned three cases, a-   Avg km has benn noted before and after installing Hho kit. ...
Post a Comment
Read more

In Spinning/weaving mill: #water and #energy #savings:

In Spinning/weaving mill: #water and #energy #savings: Water Saving: #Evaporative Cooling Systems: In many spinning and weaving mills, conventional evaporative cooling systems #waste millions of liters of water each month as water is continuously drained and replaced to maintain required #humidity levels. This water loss can be mitigated by shifting to newly designed system, which has been designed to perform the same task with significantly less water. #Electrical Energy:(about 50 to 70 kw can be saved). Along with water savings, the system reduces the need for pumping large quantities of water. Conventional systems lift about 250 gallons per minute (gpm) of water, 90% of which returns to the tank without contributing to the process. This unnecessary water movement consumes electrical power, which can be saved by using a more efficient misting system. O-End mill: (a 18 kw pump can be replaced and 100 kw chiller's can be brought about 50 kw). This less water useage can also hel...
Post a Comment
Read more