Skip to main content

Posts

Showing posts from October, 2019

how-2-save-fuel cost

Water gas Car Hho/water gas/oxyhydro gas saves fuel We conducted different test for saving CNG and patrol/gasoline fuel with HHO kit or water gas. In our experiments two strokes and 4 stroke normal engines without any alteration were used. 1- Two stroke 600 c.c 2-   Four Stroke 1000 c.c 1300 c.c. patrol engine have been used. HHo kit has been installed to produce fuel and injected it with CNG fuel via air intake filter. Fuel system: In my experiments both the types old carburetor type and modern EFI engine have been used to observe the fuel saving effect. Case -1 : HHO (about 0.0.5 to 0.75 L/min)is   added to air mixture of patrol engine of 600 c.c and 1000 c.c engine). Case-2: 1 L/Min HHO was mixed with CNG and   inducted via air intake(air filter). Case-3 About 1.75 L/min HHo gas inducted in a van having patrol engine of 2700 c.c. In all above mentioned three cases, a-   Avg km has benn noted before and after installing Hho kit. ...
21.6 km/Liter patrol and 26 Km in one lter CNG ,1989 car has given a good increase in Km by mixing HHO,water gas hydro oxy or oxyhydrogen, in Hyderabad Sindh Pakistan. HHo-fuel saving test in 1989 Car-21.6 Km/Liter Patrol

How to install HHo kit

HHO-water gas m ixing   with CNG, gives about 25-50% CNG saving. Injecting in to engine with patrol in a carburetor vehicle also give same fuel saving as we have taken in Hho-water gas with CNG. To use Hho in an efi vehicle needs some electronic circuits. How to inject HHO in CNG using vehicle? Parts required: (wire to connect with Battery and ignition switc, Relay, light, Water reservoir, bubbler, rubber  pipe. 1- Install HHO kit in a vehicle. 2- Take one wire from ignition switcch, connect it with relay coin. 3- Connect water reservoir water delivery pipe to bottom of hho kit and from gas output pipe of hho kit to the top nozzle of water reservoir. Take one pipe from water reservoir and connect with bottom nozzle of bubler and from bubler take this rubber pipe to air filter and connect it after drilling a hole in air filter. Electrical connections: 1-       Connect positive terminal with positive of kit with relay...